tube clamp features and installation procedures
2014-09-02 by bridge
Pipe clamps Characteristics Density, bending strength, impact toughness, compressive strength, elastic modulus, tensile strength, temperature. Pipe clamp installer panel assembly before welding assembly, in order to better determine the direction of the folder, it is recommended to do a good job in a fixed place mark, after welding, welding,
tube clamp on the lower half of the body inlay, put need fixing tube. Put on another half pipe clamp body and cover with screws tightened. Avoid direct soldering has been installed floor pipe clamp. Stacked assembly, rails can be
hydraulic fitting basis, or with screws, first install the upper and lower half of the pipe clamp body, put the tube clamp to be fixed on the half pipe clamps put on the body, with screws through the locking plate prevent it from turning. Then install a second pipe clamps. Elbow assembly, the assembly elbow, should be directly in front and rear elbow pipe clamp with Insein. Support points should be recommended for a fixed position.
